CNC press brake forming for consistent angles, stable fit, and repeatable production—from brackets to full enclosures

Repeatable angles and controlled bend quality Design reviewed for manufacturability (bend relief, interference, cracking risk) Supports multi-step forming and complex bend sequences Fit-oriented bending for assemblies and welded structures Cost optimization through bend simplification (DFM)

Standard: CNC bending for typical sheet metal thickness ranges and common part sizes. Extended: extra-long parts, special tooling requirements, or complex forming can be supported on request and per drawing.

Provide STEP + 2D PDF with bend notes (preferred) Define inside radius, bend direction, and cosmetic face if critical Avoid placing holes too close to bend lines without relief Consider grain direction for brushed/anodized surfaces Flag assembly interfaces and critical dimensions to control fit

Inspection per drawing requirements Reports available upon request (FAI/COC, etc.)

STEP/IGES + PDF (preferred) or DXF + PDF Material & thickness Quantity Cosmetic surfaces and finish requirement Critical angles/tolerances and fit interfaces Downstream needs (welding/assembly)

Q: Can you help optimize bend design? A: Yes—DFM suggestions available to reduce cost and revisions. Q: Do you require a flat pattern? A: Helpful, but not required—STEP + PDF is usually enough. Q: Can you hold tight angles? A: We inspect per drawing requirements; specify critical angles/tolerances. Q: Can you bend copper? A: Copper bending is available on request depending on thickness and design.